Deburring a slot opening
Remove a raised burr from the lip of the slot and smooth the opening.
DESIGNED IN GERMANY
For finishing narrow slots, inside corners, and edges on machined parts, models, sculpture, and 3D prints.
These priorities guide how the working end removes material, follows contours, and finishes edges.
Working-end durability under repeated contact with the workpiece.
Targeted material removal at small burrs and print support marks.
Steady contact when moving from a straight edge onto a curve.
Controlled flex as the working end follows curves and inside corners.
Different working diameters for narrow slots, inside corners, and edges.
Repeatable edge profiles and surface finishes on comparable parts.
The taper changes along the tool. The fine tip reaches narrow slots and inside corners. The wider section addresses edges and transitions between surfaces.
Choose an industry to explore its finishing scenarios.
Each marker points to the area to finish.
Remove a raised burr from the lip of the slot and smooth the opening.
Check the junction of the slot floor and sidewall for raised material.
After a support comes away, a raised mark can remain in the enclosure corner.
Check the rim where the enclosure meets its lid for raised spots that affect the fit.
Trim the nub left where the model part was attached to the sprue.
Check the inner window-frame edge for stray material while preserving its corners.
Locate the area to refine within a groove while preserving the adjacent raised shape.
Refine the edge where a raised contour meets the groove to clarify the transition.